- Joined
- Oct 14, 2004
- Messages
- 3,259
- Reaction score
- 63
- Points
- 48
- Location
- Bristol
- Country
- United Kingdom
I recently pushed the boat out and purchased one of these for my N.strauchii tank. As a general rule I don’t use filters on newt tanks because regular water changes and vigilant spot cleaning are sufficient for small numbers of animals. Internal filters do a good job of collecting waste and keeping the water clear but I don’t like the thought of having all that waste hidden away. In addition they invariably raise the water temperature by a degree or two.
The newts live in a 50cm x 50cm custom made tank and as they approach adulthood are starting to produce a significant quantity of waste. They’re a stream species so I was looking for a filter that offered an adjustable flow, wouldn’t heat the water and preferably take the waste out of the tank. An external canister was the only sensible option.
The Fluval 105 is the smallest in the canister range but the unit itself is surprisingly large, approximately 26cm tall by 15cm wide. It’s recommended for tank sizes of around 100 litres although my tank is nowhere near that. I’d read reviews online which suggested it was suitable for tanks of around 50 litres.
The instruction manual said to allow 40 minutes set-up time and judging by the number of parts it was probably right. The canister itself has a screen frame for foam pads and 3 baskets for filter medium. The water input, output, impeller and motor sit within a hinged top to the canister. Filter medium is supplied (carbon bags and ceramic rings) and guidance given as to which basket to place what in. It was all very straight forward and after fitting a gasket and impeller cover the canister was ready to go.
Now came the tricky part, or so it looked to me – fitting the input and output hosing. External filters are gravity fed systems and therefore the canister has to be placed below the tank. It’s a bit like a continual siphon. Gravity pulls the water into the unit and an impeller pushes water back out again. This means you have two fairly large tubes which are secured to the tank and plugged into the canister, which in my case was sitting on the floor below the tank. The obvious problem I faced was the 10cm of newt proof ledge which runs all around the top of the tank. The hose brackets supplied with the filter were designed to just hook over the edge of the tank in an upside down “U” shape. Clearly they wouldn’t fit. Out came the hacksaw and the “U” shape was quickly transformed into a right angle. This allowed me to fit the bracket to the ledge and have the tubes run down into the water.
Before starting the filter you have to pull on a little plunger which starts the siphon process and draws water into the canister. Once the gurgling stops simply plug in and away it goes. For the first few minutes air is expelled from the canister and tubing but once this process is complete the unit runs silently – eerily silent in fact.
Verdict
I would definitely recommend this filter. In the few weeks it’s been running the water has been crystal clear and I’ve noticed algal growth has reduced, suggesting there are less nutrients in the tank. The adjustable flow lever is a very useful feature, especially when feeding bloodworms which are prone to floating around in strong currents. The water temperature has decreased by a couple of degrees. Canister filters are expensive, probably twice as expensive as internal filters. This one retails at £50 - £60, but when you consider the benefits I think it’s worth the extra cash. The only con I can think of is the additional escape risk posed by the tubing into the tank. I’ve placed plastic discs around the top of the tubing to minimise this risk.
Yes, there really are 12 newts in this tank... bet you can't see one.
Last edited:
. I cannot wait to replace some of these 10 year old units I have been using!