How can I make it stick???

calinewt

New member
Joined
May 20, 2008
Messages
12
Reaction score
0
Points
1
Location
Sacramento, California
Country
United States
Hello, at work, we have some axolotls to exhibit. Their exhibit is a molded fiberglass box measuring about 3 feet long by 3 feet wide; the exhibit is also about 4 feet tall...however, we need to install a "dam" at the doorway to hold in water, because at the door, there is only about 1 inch of fiberglass...We originally used aquarium sealant to glue a plexi "dam into place along the doorway--it held, at least until a person would lean on it. I've come to the conclusion that the sealant wasn't the best adhesive to use with this.
My question is this...What would adhere plexi or another type of plastic to the molded fiberglass, and be water tight?
Any suggestions would be appreciated!
 
How about something like Instant Ocean HoldFast Epoxy Stick. It even works wet.
 
You'd have to buy it online from one of the pet product vendors.
 
I would suggest I three layered gasket approach for maximum strength. First I would go with something a bit more structurally sound than standard Plexiglas, like a polycarbonate sheet around 1/4-3/8 thick with a scratch resistant coating (available from MSC, McMaster-Carr and the like). Next I would fit the sheet for a 3/4 inch overlap with the fiberglass box and then 1/4 inch drill holes every four inches around the boundary through both the polycarbonate and the fiberglass(with the sheet inside the enclosure) dead center of the overlapped area. The next step would be to use a 1/4 inch thick bead of Aquarium silicone around the boundary. Once the sealing is in place, but still tacky, I would use 1/4-20 nylon bolts (from the industrial supply houses mentioned previously) and nuts to hold the sheet firmly in place through the holes. Have the nuts on the interior side. After allowing roughly a weeks cure time at 70F, I would re-tighten all the bolts carefully, trim off any excess bolt beyond the nut, and then apply an additional layer of aquarium sealant, or the putty described above over top the bolts and the edges of the polycarbonate sheet on the interior of the display. Another bead of silicone can be used on the exterior edges for aesthetic purposes.

If I have calculated this out properly, this set-up will not only hold the water in, but it will support the weight of the occasional lummox that may be inclined to lean on the window.
 
If it is made of Fiberglass then why not use fiberglass rein? The instant ocean hold fast epoxy is exactly the same as all the other pure, two part epoxy putties you can get and any home reno place or plastics supplier... it Just costs more. Oatey makes one and it is inexpensive enough but I would still go with the resin.
 
General chit-chat
Help Users
  • No one is chatting at the moment.
    There are no messages in the chat. Be the first one to say Hi!
    Back
    Top