Spigots on Plastic Tubs?

flyangler18

New member
Joined
Feb 1, 2008
Messages
129
Reaction score
5
Points
0
Location
Hanover, PA
Country
United States
Display Name
Jason Konopinski
Now that I've been moving toward Sterlite tubs for raising both caudates and PDFs, I've been thinking about ways to plumb drainage systems. Has anyone installed plastic spigots on Sterlite containers? Reported any failures/leaks? For the aquatic/semi-aquatic caudates, I'm trying to simplify the process of doing water changes once they are all installed on a rack.
 
I know you checked out Mark's excellent Homage to Plastic Tubs thread, but did you see this post? He describes a drainage system with siphons that have exits drilled above the water line so leaks aren't a problem. Maybe this would be a serviceable solution.

Ignore this if you've already considered that option.
 
Hi Abrahm,

I have seen that thread- and now that I think of it, may likely be an easier way to accomplish my aims with this system. It certainly would eliminate the potential problem with leaks!

Mark's design looks pretty good- and a little silicone at the joints will prevent any slippage of the lines, I suspect.

Jason
 
If by spigot you refer to a drainage hole and bung system as used in PDF rack systems then I would be cautious. The water volumes normally used in aquatic and semi aquatic newt enclosures are far greater than those typically found in the drain of a PDF viv and a leak would be quite disastrous. A PDF set-up is likely to have a misting system, reducing the impact of water accidentally draining away. It could probably be done but I wouldn’t trust plastic - it’s more flexible than glass and usually degrades over time.

If you’re feeling creative you could draw us a diagram of the system you’re aiming for and post a photo of a spigot (is it a tap?).
 
Hi Mark,

Lovely shot of the imitator, first off! I'm keeping that species myself- although I let the parents do all the tad raising :)

I did a bit of hunting on Dendroboard and discovered something that Aaron of Aaron's Frog Farm is doing:

normal_prtt2.jpg


But I agree that this does have a potential for failure given the volume of water in aquatic/semi-aquatic set up (and the pressure on the bulkhead) compared to that of your typical PDF enclosure. Keeping the drainage hole above the waterline and plumbing down to it (like your 'easy siphon' system) is what I will likely be implementing.
 
General chit-chat
Help Users
  • No one is chatting at the moment.
    There are no messages in the chat. Be the first one to say Hi!
    Back
    Top